didi
new jersey usa
Senior Member
Joined: 04/10/2002
View Profile
 Offline
|
Driveline: Workhorse Custom Chassis, 340 HP
Miles: ll,640.
Year: 2003 Airsteam Land Yacht
Breakdown Description: pull over for gas fill up, shut off engine
Symptons: never restarted, no power to key or instruments
Effect and Cause: to much of a amp load on the harness to the key. Workhorse overnighted the ignition switch kit
Outcome: This was a trip to a ill family member in Indiana, a 12 hour trip. With this breakdown it took me three days to arrive at our distination.
|
JerryKelly
Cleveland, OH, USA
Senior Member
Joined: 10/07/2003
View Profile
Offline
|
Freightliner XC Chassis, Cummins 350 ISC
Problems: Exhaust brake not working, coach surging at 66 - 70 mph.
Diagnosis: Exhaust brake not recieving power signal from the instrument panel. Surging was caused by fuel distributor in fuel pump.
The exhaust brake was diagnosed and fixed on the 2nd day. Fuel pump problem was suspected as the cause of the surging, but the Freightliner dealer was told to first diagnose the problem using Freighliner or Cummins software. It took 2 days to load the diagnostic software onto their laptop. Then Cummins took 2 more days to authorize the Freightliner dealer to work on the Cummins engine. Cummins would not ship the part until the authorization was complete (day 4). This was all due to a Cummins shop down the street. Cummins protects the turf of Cummins dealers. Freightliner could not expedite the process. Due to my Freightliner warranty, I could not go to Cummins first unless I was willing to cover the diagnostic costs in the event the surging problem was not a cummins problem. I was not told about the Cummins issue until day 4. My engine brake repair was a freightliner issue, not cummins. I got my coach back at 5:00 pm on day 5. Just in time to drive back home.
Jerry & Kelly[/blue]
Cleveland, OH[blue][/blue]
2006 Newmar Mountain Aire 4304
Note: Due to invalid formatting, all formatting has been ignored.
|
mustangman
chicago
Senior Member
Joined: 01/12/2004
View Profile
|
JerryKelly wrote:Freightliner XC Chassis, Cummins 350 ISC
Problems: Exhaust brake not working, coach surging at 66 - 70 mph.
Diagnosis: Exhaust brake not recieving power signal from the instrument panel. Surging was caused by fuel distributor in fuel pump.
The exhaust brake was diagnosed and fixed on the 2nd day. Fuel pump problem was suspected as the cause of the surging, but the Freightliner dealer was told to first diagnose the problem using Freighliner or Cummins software. It took 2 days to load the diagnostic software onto their laptop. Then Cummins took 2 more days to authorize the Freightliner dealer to work on the Cummins engine. Cummins would not ship the part until the authorization was complete (day 4). This was all due to a Cummins shop down the street. Cummins protects the turf of Cummins dealers. Freightliner could not expedite the process. Due to my Freightliner warranty, I could not go to Cummins first unless I was willing to cover the diagnostic costs in the event the surging problem was not a cummins problem. I was not told about the Cummins issue until day 4. My engine brake repair was a freightliner issue, not cummins. I got my coach back at 5:00 pm on day 5. Just in time to drive back home.
sounds like a lot of Cummins breakdowns,alot of diesel breakdowns,i can't work on them wish i knew how,thats why i trust my 460 to death ,it won't let me down knock on wood,,,want to learn diesel have to hit some books,,thanks for posting everyone,,good forum topic
|
daybreak 2001
Ontario Canada
Senior Member
Joined: 01/05/2005
View Profile
|
we had a ignition switch problem .we couldn't start the MH. after 3hrs and a towing to a garage we were on our way to get back home.
">
|
Hyrolr
The Foothills of Colorado
Senior Member
Joined: 05/09/2002
View Profile
Good Sam RV Club Member
Offline
|
Badeye:
This is a great thread. Hope you haven't bitten off more than you can chew, though.
Thanks,
...........................Tim
RV particulars: Itasca Suncruiser
Driveline (Engine, Transmission): Workhorse Vortec 7.4
Miles: 12,000
Year: 2000
Break Down Description: Three of four bolts (there are two on each side) holding the sway bar to the A frames broke. Were supposed to be grade 8 according to the markings. I called Workhorse and they said they had never heard of the problem. We have never abused the coach and it's never been off-road (use the four wheeler for that).
Symptoms: Sloppy driving, diving in corners
Effect: Made my wife nervous; then she made me nervous
Cause: Still unknown
Outcome: Out of warranty, so I talked to my neighbor (he owns a precision machine shop). He told me that they could have been foreign bolts and not really up to grade 8 standards. He gave me some new, all-american made grade 10's. I installed them and haven't had a problem since.
* This post was
edited 04/10/05 04:43pm by Hyrolr *
Tim and Christine
In loving memory of:
Greta the totally spoiled Lab
and family's best travel companion
(March 1993-July 2005)
2000 Itasca Suncruiser
2002 Chevy Trailblazer toad w/Brakebuddy
........."Life is a Highway"
|
|
|
jakcheese
Alhambra, CA, USA
Senior Member
Joined: 07/27/2004
View Profile
Offline
|
Re: bolt failure...we have 2002 Itasca 30' Sunrise. We have complained about, but replaced same bolts ourselves with other than "grade 8" from Workhorse...Same scenario, no off-roading etc. The bolts we installed have so far been fine!
While we are talking about Workhorse...ours is in the driveway with the 2nd melted ignition switch. We are 4 months out of factory warranty, but had it replaced 7/5/04 in warranty. I am awaiting a call from the dealer to see if Workhorse will step up and provide "updated" switch w/relay. Is there anything else I should do?
Jakcheese
Jackcheese and Motlah
2006 Dolphin LX 6320 W22 Workhorse chassis
|
windman2
wisconsin
New Member
Joined: 04/13/2005
View Profile
Offline
|
05 Newmar KSDP
Traveling southern Illinois on 57 where it changes to 24, I thought you guys need to spend some money fixing these roads. Drove for another 10 miles until I could'nt take it anymore. Pulled over to take a look and found my mud flap on the ground. After further review I realized I had no air in my rear end, and a threaded rod, with no nut dangled from underneath the center of the rear end. Spartan techs told me to slip it into a plate and I'd be good to go. Knowing better, I went to the closest hardware store, picked up a 11 cent lock nut and 2 washers and permanently fixed it. By the way, the rod had already come out of the bracket by the time I got to the hardware store, go figure.
|
FredC
cincinnati, oh
Senior Member
Joined: 07/15/2003
View Profile
Good Sam RV Club Member
Offline
|
We recently completed a trip from Cincinnati to Harlingen, TX where we spend almost six weeks. We then went to Big Bend National Park for a few days and then started out on I10 for Escondido, CA. We were between Fort Stockton, TX and El Paso when we had a blow out of the inside dual on the passenger side.
Good Sam had a tire guy to us in forty five minutes, which I think is pretty remarkable. Even though we had a spare, it was unusable because of its position under the RV and uncovered. So, it was struck by everything passing under the RV. LESSON: If you have a spare, and it is under the RV, cover it with something to protect it.
As a result of the spare not being good, the tire guy drove 75 miles to El Paso to pick up a new tire. Naturally, Good Sam would only pay for the cost of the guy to get us off the road. It was almost 10:00 PM when tire was finally mounted and put on the RV. We spent the night in a dirt field behind a Mexican Restaurant. The next day, we drive to Las Cruces, NM and stayed in a campground/RV repair shop named RV DOC. This shop kindly performed temporary repairs quickly so we could get back on the road.
These tires were only four and a half years old, covered when parked, inflation checked every other day when traveling, and inflated to the proper pressure. It is just one of those mysterious that happen on occasion. I did,however, buy five more tires just for the satisfaction of safety. They were Michelin XRV's 235/80/22.5.
THEN, while pulling from a fuel stop in Alpine, CA the "low water" light came on then went out. I added a little coolant, but when in Las Vegas, I noticed a drip on the parking pad. A visit was paid to the Freight Liner Oasis there and a broken radiator was found. That visit cost an extra three days and two nights in a hotel , plus a substantial repair bill.
However in seven years of RV'ing, this was our first real trouble on the road. We are home now, and by the way, I don't want to give the RV away anymore.
|
Griff in Fairbanks
AK
Senior Member
Joined: 04/21/2005
View Profile
Offline
|
For everyone with a Dodge gasoline, especially older models:
Carry a spare ballast resistor. Most are rectangular white ceramic, roughly 1" wide and 4" to 5" long, with two electrical connectors and a single mounting screw. Unlike voltage regulators and starter relays, ballast resistors are not grounded and may be mounted on nonconducting material such as plastic.
The ballast resistor reduces voltage to the coil, thereby increasing sparkplug life. The starting circuit bypasses the ballast resistor, resulting in a hotter spark when starting.
Symptoms of a bad ballast resistor: Your vehicle fires while you hold the key in the start position (because of the bypass) and dies as soon as you let go of the key (because in the run position, current is supplied to the coil through the ballast resistor).
I haven't bought one in a while but I seem to recall that my spares were less than $20.
As an emergency fix, you can connect the two electrical leads together but doing so will shorten the life of your sparkplugs and other ignition components.
I first encountered this problem on my '77 Dodge B200 van, purchased new and well maintained. My 1970 Explorer motorhome, on a 1969 Dodge M300 chassis, also has a ballast resistor but hasn't needed a new one yet.
The bad ballast resistor kept my van from going anywhere and frustrated me because I couldn't figure out what was wrong. (I'm a fairly good mechanic with extensive knowledge of the electrical systems in older vehicles - I can draw most of the typical wiring diagrams from memory.) A friend suggested I check the ballast resistor, saving me the expense of a tow. (I bought him a case of his favorite beer in thanks.)
I've heard of enough similar experiences from other people to convince me to always carry a spare. I haven't heard of any going out while the vehicle is moving although I imagine it's possible. All of the cases I've heard of showed up while trying to start the vehicle, leading me to believe a current spike during shutdown or starting cause the ballast resistor to fail.
Hope this helps someone.
1970 Explorer Class A on a 1969 Dodge M300 chassis with 318 cu. in. (split year)
1972 Executive Class A on a Dodge M375 chassis with 413 cu. in.
1973 Explorer Class A on a Dodge RM350 (R4) chassis with 318 engine & tranny from 1970 Explorer Class A
|
CrabbyCamper
Oregon, USA
Full Member
Joined: 04/25/2004
View Profile
Offline
|
RV particulars: 1997 Fleetwood Bounder 28T
Driveline (Engine, Transmission): Chevy 454
Miles: 35,000
Year: 2004
Break Down Description / Symptoms: Going up the hill out of Yreka CA the engine started making this sound like air was popping out of the cylinder with each stroke. Then there was a pop and it sounded a lot louder.
Effect: I pulled over to the side and called for assistance.
Cause: One of the spark plugs had come loose and popped out.
Outcome: It didn’t take the threads with it, so they put a new sparkplug in and I was back on the road.
|
|
|
|
