blaczero
USA
Full Member
Joined: 10/16/2020
View Profile
Offline
|
When i wiggle the 12v hot wires going into my water pump, it runs. If I don't touch them, nothing.
I have to hold one of the wires in an exact spot for it to continue to run.
I tested and it's getting 12v
It's a seaflo water pump with strainer.
a lot like this one https://www.amazon.com/Diaphragm-Priming-Gallons-Marine-Demand/dp/B00P8BE6S8/
I cannot pull the wires out to inspect and I cannot take it apart right now (night time). I will in the morn
Should I get a new pump or keep trying to repair this one?
|
Bobbo
Wherever I park
Senior Member
Joined: 09/16/2007
View Profile
Good Sam RV Club Member
Offline
|
Sounds like a broken connection. If you can open it and find the break to fix, fine. If not, replace it.
Bobbo and Lin
2017 F-150 XLT 4x4 SuperCab w/Max Tow Package 3.5l EcoBoost V6
2017 Airstream Flying Cloud 23FB
|
enblethen
Moses Lake, WA
Senior Member
Joined: 01/05/2005
View Profile
Offline
|
Are wiggling wires into pressure switch or motor itself? Shurflo sells pressure switches.
Bud
USAF Retired
Pace Arrow
2003 Chev Ice Road Tracker
|
ScottG
Bothell Wa.
Senior Member
Joined: 02/25/2005
View Profile
|
I would check the wire connectors where they attach to the switch on the pump.
|
midnightsadie
ohio
Senior Member
Joined: 01/07/2008
View Profile
Offline
|
all great advice but I,d start where the pump wires get there source of 12v .and work towards the pump.
|
|
blaczero
USA
Full Member
Joined: 10/16/2020
View Profile
Offline
|
The right hand side, the 2nd wire in, that is the one that i have to hold or jiggle to get the pump going. I don't know if it's hard wired in, but I will take it apart today.
|
enblethen
Moses Lake, WA
Senior Member
Joined: 01/05/2005
View Profile
Offline
|
That is the contacts of the pressure switch. It has a 1/4-inch quick connector. Could be loose Should pull off. Should be tight
|
wa8yxm
Davison Michigan (East of Flint)
Senior Member
Joined: 07/04/2006
View Profile
Offline
|
Had that happen with a piece of electronics here in my apartment
One of the wires was broke When I wiggled it the fact became obvious (Built in diagnostic flagged it) This was a werid one as the break was mid-run.
On the Motor home I had a bunch of stuff stop workign.. Here is the circuit
Battery-fuste---wire to distribution panel-- branch circuits to stuff.
The wire.. had a "Fault" (not a break) mid run and I was able to cut and splice and excise the fault.. All good after that.
Home was where I park it. but alas the.
2005 Damon Intruder 377 Alas declared a total loss
after a semi "nicked" it. Still have the radios
Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times
|
Bobbo
Wherever I park
Senior Member
Joined: 09/16/2007
View Profile
Good Sam RV Club Member
Offline
|
I had to replace the power cord to the monitor for my Airstream's backup camera. One of the wires had a break right at the connector. It would only work if I was pushing the wire in and down. After replacement, no further problems. It does happen.
|