deadticket8
All over
Senior Member
Joined: 02/10/2006
View Profile
Good Sam RV Club Member
Offline
|
Hello
Any help appreciated
Atwood furnace afsd20121 Winnebego micro 22'
At first would work a couple of cycles then no ignition. Reset and that is an issue as furnace has no outside access and well, lot of work to pull out
1. cleaned sail switch of dust bunny
2.furnace fired up
3. then fan only
As of last night new dinosaur board but bought from Amazon. Fan only no ignition
board locked out and fan would not restart although I reset
Today still no fan. Long story short.....
1. jumped out tstat and limit switch(which had continuity but to make sure) Installed new sail switch.
2. power at reset and connection on board for power. Nothing coming from fan conn on board.
all connections look good, seems to be in board. I reinstalled old board, same result.
I'm thinking I got a bad board from Amazon.
Thoughts?
3
|
enblethen
Moses Lake, WA
Senior Member
Joined: 01/05/2005
View Profile
Offline
|
Manual
Page 6 lower left corner says there is a switch to inhibit propane valve from operating. Shown on circuit drawing page 7 left side.
Have you seen such an item in yours?
Bud
USAF Retired
Pace Arrow
2003 Chev Ice Road Tracker
|
deadticket8
All over
Senior Member
Joined: 02/10/2006
View Profile
Good Sam RV Club Member
Offline
|
Gas valve is not easily accessible but I will definately check that out later. Great information.
|
deadticket8
All over
Senior Member
Joined: 02/10/2006
View Profile
Good Sam RV Club Member
Offline
|
Reading the bottom of page 6 it says the blower will operate with the switch on or off. My blower is not operating.
* This post was
edited 11/13/23 10:18am by deadticket8 *
|
enblethen
Moses Lake, WA
Senior Member
Joined: 01/05/2005
View Profile
Offline
|
Are you getting power to the furnace?
Is there power to both sides of the switch/circuit breaker?
|
|