dalefuji
Milton, Pa.
Full Member
Joined: 07/14/2010
View Profile
Offline
|
Generator runs sometimes and then shuts off.
Replaced with new:
Spark plugs, oil change, oil filter, air filter. "still no run"
Replaced:
New carburetor, New fuel pump, New fuel filter, No gas line hose from carburetor to fuel pump.
"still no luck"
The in line 10 amp fuse above stop/start switch is okay. The 20 amp
two blade fuse by breakers is okay.
I help "stop button" in for 15 seconds to prime Gen. and then hit start button and it started and ran for 60-90 seconds and then started getting rough and shut off and would not start.
I ordered new 5 blade relay plug under air intake to see if that is problem.
Are there any other in line fuses that could be problem
Any suggestions would be greatly appreciated.
|
Matt_Colie
Southeast Michigan
Senior Member
Joined: 10/09/2011
View Profile
Offline
|
You need to make some friends at a local small engine shop. Onan engines are all over the place and they will probably have seen this before.
Matt_C
Matt & Mary Colie
A sailor, his bride and their black dogs (one dear dog is waiting for us at the bridge) going to see some dry places that have Geocaches in a coach made the year we married.
|
enblethen
Moses Lake, WA
Senior Member
Joined: 01/05/2005
View Profile
Offline
|
Stop throwing money at it!
Have you checked for spark at the spark plugs?
Possible bad coil or plug wires.
Does it make any attempt to fire? Any back firing?
Bud
USAF Retired
Pace Arrow
2003 Chev Ice Road Tracker
|
dalefuji
Milton, Pa.
Full Member
Joined: 07/14/2010
View Profile
Offline
|
thanks, I will check for spark.
How do I get a manual for this Model (1997)
|
enblethen
Moses Lake, WA
Senior Member
Joined: 01/05/2005
View Profile
Offline
|
Check Ebay for manual.
|
|
johnhicks
Wandering below the Gnat Line
Senior Member
Joined: 08/29/2013
View Profile
Offline
|
Is it making electricity when it's running?
-jbh-
|
dalefuji
Milton, Pa.
Full Member
Joined: 07/14/2010
View Profile
Offline
|
doesn't run long enough to check. Besides I had breakers turned off on Generator.
|
Rick Jay
Greater Springfield area, MA
Senior Member
Joined: 02/02/2003
View Profile
Offline
|
dalefuji,
Did you replace the gas line from the fuel pump to the gas tank?
If it ran when you primed it, you filled the float bowl with fuel and that allowed the generator to run for a short while. But with a leak in the line between the fuel pump and the gas tank, fuel can't be sucked up fast enough and the engine will stall.
One way to check is to take a line from the fuel pump into a separate gas container and see if the engine will keep running then.
Good Luck,
~Rick
2005 Georgie Boy Cruise Master 3625 DS on a Workhorse W-22
Rick, Gail, 1 girl (27-Angel since 2008), 1 girl (22), 2 boys (23 & 20).
2001 Honda Odyssey, Demco Aluminator tow bar & tow plate, SMI Silent Partner brake controller.
|
LouLawrence
Traveling the US fulltime since 2000.
Senior Member
Joined: 03/16/2021
View Profile
|
^^^^This is what I would be looking at. An issues somewhere with the fuel line running from tank to generator. If it's sucking air along with the fuel it won't run for long.
|
dalefuji
Milton, Pa.
Full Member
Joined: 07/14/2010
View Profile
Offline
|
I took fuel line from fuel pump and stuck it in gas can and no luck still doesn't run.
I checked old carburetor and it seems clean and okay. I think the new carb. is stuck and not working properly.
|
|