dhull
Some Lake Somewhere
Full Member
Joined: 08/05/2015
View Profile
Offline
|
Changing out a Thetford style II toilet. At the water Inlet from camper the fitting has a rubber gasket inside it. Tried picking it out but it does want to pop out. It's a little deformed and previously leaked until tightened.
So I'm wondering if it should pop out and I can replace it. Or is it built in to the fitting?
Is this the PEX stuff?
|
QCMan
Independent Republic of Horry
Senior Member
Joined: 12/19/2005
View Profile
Offline
|
Most fittings will leak until tightened. Clean it and tighten it so it does not leak. They are fairly resilient.
2020 Keystone Cougar 22RBS, Ram 1500, two Jacks and plenty of time to roam!
The difference between genius and stupidity is that genius has its limits. A.E.
Good Sam Life Member
|
wolfe10
Florida
Senior Member
Joined: 10/08/2000
View Profile
Offline
|
Could be a common RV washer: https://parts.unitedrv.com/products/1-2p-cone-washer
The little tabs keep it in place/a little more difficult to remove.
Any RV shop will have them.
Brett Wolfe
Ex: 2003 Alpine 38'FDDS
Ex: 1997 Safari 35'
Ex: 1993 Foretravel U240
Diesel RV Club:http://www.dieselrvclub.org/
|
ScottG
Bothell Wa.
Senior Member
Joined: 02/25/2005
View Profile
|
Yes, it will pop out and you can get a replacement at HomeDepot like the part Mr. Wolfe shows above.
|
dhull
Some Lake Somewhere
Full Member
Joined: 08/05/2015
View Profile
Offline
|
Did get it out.
Thanks!
|
|