mellow
Salisbury, MD
Senior Member
Joined: 06/10/2014
View Profile
Offline
|
Keep an eye out on ebay or fb marketplace, some show up from time to time.
2002 F-350 7.3 Lariat 4x4 DRW ZF6
2008 Lance 1191 - 220w of solar - Bring on the sun!
|
Ernie Fergler
Iowa
Full Member
Joined: 02/25/2006
View Profile
Good Sam RV Club Member
Offline
|
Thx one and all.I ordered torklift springs last night.
|
mbloof
Beaverton, OR
Senior Member
Joined: 11/27/2014
View Profile
Offline
|
Ernie Fergler wrote:Thx guys. The Torklift springs seem a little pricey for what they are. Any alternatives?
"HappyJack" does make spring loaded turnbuckles for a fraction of the cost of the overpriced TL models.
Similar to TL, HappyJack makes short ones (generally used in the front bed mount) and long ones.
Take your pick.
- Mark0.
|
greenno
Clairemont Cal.
Full Member
Joined: 04/12/2018
View Profile
Offline
|
I went with the lower priced Happyjack “fastgun” style turnbuckles.
That being said I also went with the Torklift frame mount tie downs.
They have worked out just fine and saved a couple bucks too.
|
stevenal
Newport, OR, USA
Senior Member
Joined: 03/16/2004
View Profile
Offline
|
I believe the HJ Quick-loads have springs on the front only.
'18 Bigfoot 1500
Torklifts and Fastguns
'17 F350 Powerstroke Supercab SRW LB 4X4
|
|
greenno
Clairemont Cal.
Full Member
Joined: 04/12/2018
View Profile
Offline
|
Ehh incorrect on the HJ not being spring loaded.
I have had these "fastgun" style turnbuckles and they have internal springs on front and rear.
Typically want about 1/4" of stretch when properly tensioned and set in place.
Of course you can also lengthen and shorten overall length as required.
|
stevenal
Newport, OR, USA
Senior Member
Joined: 03/16/2004
View Profile
Offline
|
Qwik-Loads
Quote:Front turnbuckles are spring loaded to help reduce stress on tie-down points
Rear turnbuckles are cushioned with rubber
Ensures proper amount of tension for bumper-mounted tie-downs while still minimizing stress on tie-down points
Perhaps it's possible to buy four fronts somewhere.
|
Grit dog
Black Diamond, WA
Senior Member
Joined: 05/06/2013
View Profile
Offline
|
stevenal wrote:Qwik-Loads
Quote:Front turnbuckles are spring loaded to help reduce stress on tie-down points
Rear turnbuckles are cushioned with rubber
Ensures proper amount of tension for bumper-mounted tie-downs while still minimizing stress on tie-down points
Perhaps it's possible to buy four fronts somewhere.
Still over $100 more expensive than the basic Torklift turnbuckle/spring mount combo sets.
If the OP wants a proper connection that is pre engineered, I think those are the most reasonably priced.
Maybe I forgot but I thought the point of the OPs query was economical tie downs.
2016 Ram 2500, MotorOps.ca EFIlive tuned, 5” turbo back, 6" lift on 37s
2017 Heartland Torque T29 - Sold.
Couple of Arctic Fox TCs - Sold
|