JDemers
Pennsylvania
New Member
Joined: 04/28/2023
View Profile
Offline
|
I’m looking at a Host Camper and have a GMC 3500HD truck. Does anyone know if I will have to remove the trucks stock antenna for the satellite radio before I mount the camper in the bed? Thanks in advance.
|
LadyRVer
Florida
Senior Member
Joined: 09/04/2007
View Profile
Offline
|
I didn't have to.
|
ssthrd
Vancouver Island
Senior Member
Joined: 03/23/2016
View Profile
|
^^Neither did I, but I believe that the camper's aluminum frame interferes with reception. Everything works fine without it. I have not looked into a fix for that, but I'm sure there is one........
EDIT:
Seek and ye shall find. I know this doesn't answer your question, but I found a solution to my concern here
I will measure the clearance I have and post tomorrow. My guess is about 3".
* This post was
edited 05/13/23 09:04pm by ssthrd *
2014 Keystone Laredo 292RL
2013 Palomino Maverick 2902
2018 GMC 3500HD, 4x4, 6.5' box, SRW, Denali, Duramax, Andersen
DeeBee, JayBee, and Jed the Black Lab
The hurrier I go the behinder I get. (Lewis Carroll)
|
JDemers
Pennsylvania
New Member
Joined: 04/28/2023
View Profile
Offline
|
Thanks for the replies. SSTHRD thanks for the link to install a new antenna. A lot of helpful information.
|
ssthrd
Vancouver Island
Senior Member
Joined: 03/23/2016
View Profile
|
This is for my particular camper. Yours may be different.
It’s sitting on a ¾” stall mat, and I have about 5 ½ “ clearance over the antennae and about 7 ¼” between the cab and the overhang. 51” from bottom of camper to underside of overhang.
Hope this helps.
* This post was
edited 05/14/23 11:48am by ssthrd *
|
|
Yeti plus
S.W. Ontario
Senior Member
Joined: 08/22/2012
View Profile
Good Sam RV Club Member
Offline
|
I tried those magnet mount antennae. Did NOT work on my 2014 Chev. I tried 3 of them.
I bought this and I am getting about 3 years of use. I have a piece of aluminum flat stock, that I drilled a hole in to fit the antenna, then fastened to truck by removing a bolt and then replacing it holding the flat stock in place.
Brian
2014 Chevrolet 3500 CC 4X4 Duramax, Tork Lift Tiedowns, TorkLift Fastguns, Superhitch and supertruss
2009 Jayco 213 SOLD
2008 Bigfoot 25C9.4
|