mkirsch
Rochester, NY
Senior Member
Joined: 04/09/2004
View Profile
|
I'm not seeing how a line on the ground will help. Can't even see the ground from the driver's seat, and even if I could, what would I line up against?
Everyone's situation is different to a degree. In my case if I squeak between the jack feet with my tires, I'm lined up.
Putting 10-ply tires on half ton trucks since aught-four.
|
JRscooby
Indepmo
Senior Member
Joined: 06/10/2019
View Profile
 Offline
|
mkirsch wrote:I'm not seeing how a line on the ground will help. Can't even see the ground from the driver's seat, and even if I could, what would I line up against?
Everyone's situation is different to a degree. In my case if I squeak between the jack feet with my tires, I'm lined up.
Most vehicles I have driven have mirror adjusted so can see sidewall of rear tires.
Squeak between jacks at wrong angle could have issues. I can see how something to line up on so going straight at start of squeak would help.
|
otrfun
On The Road
Senior Member
Joined: 09/08/2012
View Profile
Good Sam RV Club Member
|
Wow, gotta be more than "50 ways to" load your camper--lol!
We attach strings between the front/rear jack legs on each side, using wide painter's tape--takes about a min. As we backup, we use the ends of all four torklift extensions, the strings, and jack legs as guides. Since this is a 4-point approach, it's makes it easier to get an accurate parallel and side-to-side alignment between the truck and camper. Usually 1 or 2 corrections and we're in. Works great for us! YMMV.
|
mbloof
Beaverton, OR
Senior Member
Joined: 11/27/2014
View Profile
Offline
|
This is what I ended up doing. After measuring the inside width of my tail gate opening I then centered two nylon straps on my camper placed at the same width -1".
Then using one (or both) mirrors - I aim one of the trucks bed rails just to the outside of one of the straps.
![[image]](https://live.staticflickr.com/65535/52783889907_9031292549_z.jpg)
It works every time as long as you can see one of the ends of your bed rails in your mirror(s).
- Mark0.
|
mkirsch
Rochester, NY
Senior Member
Joined: 04/09/2004
View Profile
|
JRscooby wrote:mkirsch wrote:I'm not seeing how a line on the ground will help. Can't even see the ground from the driver's seat, and even if I could, what would I line up against?
Everyone's situation is different to a degree. In my case if I squeak between the jack feet with my tires, I'm lined up.
Most vehicles I have driven have mirror adjusted so can see sidewall of rear tires.
Squeak between jacks at wrong angle could have issues. I can see how something to line up on so going straight at start of squeak would help.
In my case you're not squeaking through at an angle. If you fit, you're straight.
Even if I adjust the mirror to see the tires, I still don't see what having the line accomplishes. You need a line to sight against a line. A tire is just a point.
|
|
|
liamricci
Texas
Full Member
Joined: 09/26/2021
View Profile
|
How is the result? Do you mind sharing? Need to do a driveway myself, need some inspiration.
|
Cristian123
Phoenix, USA
Full Member
Joined: 02/22/2020
View Profile
Offline
|
I'm also in the process of doing a driveway. I've already ordered curb ramps (found useful info and reviews here https://curbrampreviews.com/, maybe this source will be useful for someone else) and now I'm waiting for the contractors to come and pave the driveway. Thanks for the helpful info and tips!
* This post was
edited 11/07/23 09:08am by Cristian123 *
|
Atchafalaya_man
Lafayette, Louisiana
Senior Member
Joined: 08/24/2009
View Profile
Good Sam RV Club Member
Offline
|
I used some 'Mule Tape' or 'Pulling Tape' because it's flat and does not stretch or roll/slide like round rope or string.
You have to determine exactly WHERE to position the tape under the camper relative to where your tire will pass and backing is a one-pass-move most times.
https://www.amazon.com/2500-tensile-Polyester-Pull-Webbing/dp/B07X8DKY96/ref=sr_1_8?keywords=mule+tape&qid=1699650475&sr=8-8
|
LMHS
NM
Full Member
Joined: 06/27/2022
View Profile
|
Have a center mark on the lower front of the camper floor and a matching mark on the tailgate side of the truck bed (the tail gateis removed. We put it there with a permanent marker and periodically remark it when it fades too much.
Bought a piece of pvc "veranda/trex" porch decking, cut in half to make two pieces, that are used as spacers between the wheel wells. These boards run from the front of the truck bed all the way back to just in front of the rear truck bed pillars. They are slick enough that the camper box will slide down one or the other with little friction. There is about 1/2 inch space on each side between the wheel well + spacer boards and the camper box sides.
I aim for matching up the center marks and the boards tend to push the camper box straight. I do have to watch the grey water tank that is mounted under the galley side so that the top edge of the truck bed doesn't get too close.
It's all a tight fit. I usually take up to 3 tries to get lined up correctly. I normally have my daughter guide me back (it's her camper) but I have loaded it by myself. It's no more difficult than it was to get the popup hitch lined up. If anything, it's easier.
There are also a couple boards laying across the front of the truck bed so the camper box will slide up and touch when it is in far enough. This is because the Stabile Lift has to line up with the saddle brackets that are underneath the truck.
|
MORSNOW
Mountain Home, ID
Senior Member
Joined: 10/29/2013
View Profile
Good Sam RV Club Member
Offline
|
It's obvious that we all have different ideas that work for us depending on our trucks and campers characteristics. My GM truck box tapers and is narrower in the rear, so trying to back in using my mirrors and following the box position has proved to be futile for me. The line in the center of the camper and on the box floor was my best bet, but that only worked for the first foot or so where I could see into the box. A few years ago I invested in a Camper Cradle, it has been awesome. I can now just back in with a rubber roller as a guide and perfectly centered all the way in. A HappiJac front support bar with centering guides centers and holds the front perfectly centered also. I never have to adjust my Fastguns, and my side mirror vision is the same every time.
![[image]](https://i.imgur.com/TMWK2Tfl.jpg)
![[image]](https://i.imgur.com/9vvjOVFl.jpg)
2014 Wolf Creek 850SB
2012 GMC Sierra SLT 2500HD
7,220# Truck/10,400# Camper Fully Loaded
|
|
|
