![[image]](http://i67.tinypic.com/1z2q0x4.jpg)
1970 Explorer Class A on a 1969 Dodge M300 chassis with 318 cu. in. (split year)
1972 Executive Class A on a Dodge M375 chassis with 413 cu. in.
1973 Explorer Class A on a Dodge RM350 (R4) chassis with 318 engine & tranny from 1970 Explorer Class A
Any idea which size of heat shrink for which diameter of wire? And what size are those ICM wires?
Measure the diameter of your wires and get the next bigger size or two steps larger. (Calipers if you have a set or a tape measure and mark one eyeballs.)
You do need a micrometer. I do have one but I would need to cut a wire to measure it.
TreeSeeker wrote:
Here is how to find wire guage.
You do need a micrometer. I do have one but I would need to cut a wire to measure it.
Here is how to find wire guage.
You do need a micrometer. I do have one but I would need to cut a wire to measure it.
That's why I keep mine on the spool and only use odds & ends for jumpers and testing.
Figuring out what size wire is in a circuit is trickier, as you indicated. I try to figure out what size it is and go one size larger. (Slightly larger never hurt ... much larger doesn't hurt either but wastes money.)
Having said that, the size of heat shrink tubing needs to be at least as large as the outside diameter of the wire insulation. Two or three sizes larger, depending upon the size of the terminal crimp barrel or your splice. The neater your splice, the smaller the tubing can be, as long as the tubing fits over the splice.
The tubing shrink a lot so somewhat larger tubing will work.
BTW - I normally used uninsulated wire crimp terminals. I also solder the wire inside the terminal barrel after I crimp it. Final step is slide the tubing over the barrel and heat shrink it.
If I don't have uninsulated terminals, I strip the plastic 'insulation' off readily available terminals.
Also, heat shrink tubing, if it's an inch or so longer, serves as stress relief. (A double layer of tubing, if I think the wire will experience a lot of stress at the terminal.)
* This post was edited 10/04/17 07:43am by Eric Hysteric *
'79 Dodge Sportsman 5.9 LA 360 TEC Campmate
Bit of other news... for the first time since I've owned it... I think the exhaust is finally fixed and without issue. Put a new muffler and tailpipe on last fall, found a crack and a leak up by the manifold and got that and the header gasket fixed. just kinda purrs now. My oldest said it doesn't sound as powerful now. lol. Should be a nice trip this weekend.
Have a great trip!