| |
Subject |
Author |
Date Posted |
Forum
|
 |
RE: Underground 250ft run
I would find out electrical code in your area for buried wiring.
|
Gary45
|
03/30/23 07:27am |
Tech Issues
|
|
RE: House Batteries not being charged by engine.
Battery isolator module in engine compartment???
|
Gary45
|
12/18/22 03:49pm |
Tech Issues
|
|
RE: Generator issue
What year is the generator? The unloaded voltage should be higher. Do you have a frequency setting on your meter to check frequency? The newer gennys have electronic voltage control, I have one from the 80's, transformer voltage control, when unloaded it puts out around 130 volts and around 62 cycles, when I turn AC on the genny rpm drops a bit and then revs up to carry the load. You can measure the volts and frequency at any outlet inside the motorhome. Neutral, white wire, to ground should be 0.
|
Gary45
|
10/13/22 07:55am |
Tech Issues
|
|
RE: Onan 3.6 won't crank
On the wiring diagram it has the jack pin out where you could see if you have 12 volts at the control board. It is kind of strange, no fuse, you might need the control board. If it was mine I'd be inclined when all figured out to add a fuse.
|
Gary45
|
09/20/22 04:20pm |
Tech Issues
|
|
RE: Onan 3.6 won't crank
This url will take you to a page for your unit, there is a download section where manuals are, in the operator manual section 4 page 21 there appears to only be an AC breaker. This manual does not have a wiring diagram unfortunately. I did find another manual with a wiring diagram, it showed 12 volts going directly to control board, I'll find it again and post link however while it's for a 3.6 not exactly the same model.
https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=&ved=2ahUKEwi4x9r9oKT6AhVIhIkEHY01CR8QFnoECBAQAQ&url=https%3A%2F%2Fwww.coloradostandby.com%2Fcummins-onan-3-6-ky-fa-26120-rv-or-commercial-generator-set-rv-qg-3600-lp&usg=AOvVaw2EMtr_TesUTaxXFTnvSi-u
|
Gary45
|
09/20/22 03:17pm |
Tech Issues
|
|
RE: Onan 3.6 won't crank
There is more than one type 3.6, the full model number would help.
|
Gary45
|
09/20/22 10:10am |
Tech Issues
|
|
RE: Onan 3.6 won't crank
On the the Onan there should be a small plate with the model number and serial number that's the info you need to search the internet accurately, the manuals are online. The 3.6 should flash out an error code on the stop start switch led
|
Gary45
|
09/11/22 10:42am |
Tech Issues
|
|
RE: Onan 3.6 won't crank
Assuming the info I found on the internet for Onan 3.6 is the model your friend has shows in a pic location of fuse, sort of on the right bottom corner side. My 4000 has it on the front of the control panel.
|
Gary45
|
09/11/22 07:05am |
Tech Issues
|
|
RE: Onan 3.6 won't crank
There should be a 12 volt fuse near the control panel on the generator. If bad will not crank.
|
Gary45
|
09/05/22 10:37am |
Tech Issues
|
|
RE: Holes in Fiberglass Roof
A coating of ProflexRV will seal and protect.
|
Gary45
|
08/28/22 10:32am |
Tech Issues
|
|
RE: finding the leak
What year is your trailer? Does it have aluminum roof or rubber roof? Different problems depending on material.
|
Gary45
|
08/22/22 07:29am |
Tech Issues
|
