Open Roads Forum

Print  |  Close
Page of 312  
Prev  |  Next

Topic: So what did you do to your Truck Camper today?

Posted By: Chief 2 on 12/13/11 04:29am

Did some more insulation of dead spaces. Found that my entire compartment where my water pump is going up behind my shower had zero insulation in it plus a good size cut out leading into the bathroom cabinet. I purchased some small bags of batt insulation from Lowes and stuffed it up there. Even though I couldn't get all the way to the top of the wall it has to help some. Next is under the bed and the wall behind the bathroom cabinet with some foam board.


2005 Lance 1181 Loaded
2005 Chevy 3500 4X4 Duramax, Edge Attitude Tuner, 5" Exhaust, Airaid, Ranchos, Air Bags, Hellwig Big Wig
2007 38RL3 Mobile Suite
2001 Bass Tracker 185


Posted By: Mello Mike on 12/13/11 05:59am

Just finished driving the historic and scenic Apache Trail. Here are a few pics, more can be found in my blog.

[image]

[image]

[image]


2016 Northstar Laredo SC/240w Solar/2-6v Lifeline AGMs/Dometic CR110 DC Compressor Fridge
2013 Ram 3500 4x4/6.7L Cummins TD/3.42/Buckstop Bumper with Warn 16.5ti Winch/Big Wig Rear Sway Bar/Talons w/SS Fastguns
My Rig
1998 Jeep Wrangler
US Navy Ret.


Posted By: RockyRoadCamper on 12/13/11 08:07am

Where is Apache Trail?


Posted By: Mello Mike on 12/14/11 02:50pm

RockyRoadCamper wrote:

Where is Apache Trail?


Central Arizona.


Posted By: Parts Jimmy on 12/14/11 03:01pm

Looks like a nice project.


2000 Ford F350 Power Stroke Diesel
2005 Northstar 8.5 Adventurer
2007 Sea Pro 195FS

My Photo Album


Posted By: GoinThisAway on 12/14/11 06:51pm

Installed a set of Torklift Stable Loads.


2008 Dodge 3500 DRW 4x4
2008 Bigfoot 25C10.4
Torklift/Fastguns/Hellwig/StableLoads


Posted By: Chief 2 on 12/15/11 05:55am

Finished up insulating under the bed and the bathroom cabinet area. The only place I have left is the closet, but not sure about putting the foam board in there. Any one have any ideas of using something different?


Posted By: mountainkowboy on 12/15/11 09:25am

Putting it back up on the truck and working alittle more on the inside.


Chuck & Ruth with 4-legged Molly
2007 Tiffin Allegro 30DA
2011 Ford Ranger
1987 HD FLHTP



Posted By: garryk6 on 12/15/11 12:39pm

Chief 2 wrote:

Finished up insulating under the bed and the bathroom cabinet area. The only place I have left is the closet, but not sure about putting the foam board in there. Any one have any ideas of using something different?


Try "Reflectix" it is a double-foil-backed bubble-wrap insulation. Make sure to spray-glue, or seal edges with foil-duct-tape to keep moisture from getting behind it. I have insulated most of my camoer with it, and we survived a week of single-digit weather with a few nights to -9F. It is only 1/4" thick, so it doesn't take as much space away, which is important on a camper!

Garry in Kodiak, AK


Garry K
Wife + 4 kids
Retired Military Family.... Alway's on the move....
2002 F350 CCSB 5.4 6spd 4x4 in AK
1966 Avion C-10 Truck Camper



Posted By: JumboJet on 12/17/11 04:05pm

Replaced Sure Power 1314 Isolator with the 1314A. Tested the isolator by connecting to my truck and observed with a volt meter while the intake heater grid was cycling on my cold Dodge Ram. Solenoid would click - voltage would go up to 13.nn on the camper battery pole. Solenoid would click and voltage drop to 12.nn on the camper battery pole. After several off/on cycles, I buttoned it all up and called it good.

Moved the battery disconnect switch that was hidden under the step to the slide-out to next to the slide-out override switch. What engineer decided to locate that switch in such an inconvenient place?


Print  |  Close
Page of 312  
Prev  |  Next