Mkos1980
Macedonia Ohio
Senior Member
Joined: 10/17/2004
View Profile
 Offline
|
I bought a used TT and it had a mount on it for a sway bar already. My Eaz Lift bar says 24inches from center of the ball back. This mount has the ball at 25 inches. Will this be ok? I dont really want to drill anymore holes then I have too. Thoughts?
2003 Springdale 269RLLS TT
1990 Chaparral 2150SX 350 MAG
2006 Chevrolet 2500HD 6.0
1989 Pontiac Formula 350 "LSX"
|
Wills250psd
on the road
Senior Member
Joined: 08/13/2011
View Profile
Good Sam RV Club Member
|
its should be 24" but it should be okay as long as you dont turn 90 degrees which is nearly impossible going forward but is possible in reverse. but the sway bar should be removed when your backing up.
|
jerem0621
SE Tennessee
Senior Member
Joined: 05/17/2009
View Profile
Offline
|
You will have no problem....
X2 on removing before backing.. Its not worth damaging your sway bar or your hitch to save the 30 seconds it takes to remove the the sway bar.
and it is not worth the extra 4-6 holes that you will have to drill just to move it one inch..
No worries,
Enjoy your new travel trailer..
Jerem
TT: 1995 Layton 2910
Tow Vehicle: 1999 F-350, v10, , 2wd, Crew Cab, Dually
Hitch: Draw-Tite Trunnion WD Hitch with Reese Dual-Cam sway control
|
SoCalDesertRider
SanDiego, CA, USA
Senior Member
Joined: 12/14/2003
View Profile
|
I forget the measurement but I welded mine on. No worries about holes. 
05E350 6.0PSD
97F350DRW 7.3PSD 4x4 4.10 11' flatbed
98Ranger
69Bronco ATC250R CR500
20' BigTex flatbed carhauler
Callen Camper
92F350 CrewCab 4x4 351/C6
B&W TurnoverBall, Curt Magnum V
HD Springs Bilsteins,
285/75-16E BFG AT on 16x8 Stocktons
4.56's & LockRite rear
|
eric james
Sioux Falls, SD
Senior Member
Joined: 07/21/2004
View Profile
Offline
|
When the comment "remove before backing" it's about backing into a campsite (or the like) where you will make sharp angles.
2009 Keystone Passport UL 290BH
2003 Ford Expedition EB 5.4L/3.73
|
|
|
