beemerphile1

I'm only 57, I'm not yet a

Senior Member

Joined: 04/20/2007

View Profile


Good Sam RV Club Member
Online
|
A fellow RVer tells me that they have a rubber connecting hose on the permanently installed furnace. Anyone else have this? Both of mine are hard piped with copper to the furnace gas valve. I know it would never meet muster in sticks/bricks installation. Does RVIA allow this?
I'm not talking about a hose for a Wave or other heater but the permanently installed LPG furnace. It seems like a really bad idea to me to have a rubber hose snaking inside a cabinet where it will seldom be seen or inspected. What do you have?
Tim
If you aren't paranoid, you aren't paying attention! 
2006 Weekend Warrior FK1900 towed by 1998 Ford E150 4.6L = 8 MPG
2009 Aliner Sport towed by 2009 Pontiac Vibe 1.8L = 22 MPG
1996 BMW R1100GS
|
Chris

Shelter Bay, Wa

Senior Member

Joined: 12/19/2000

View Profile


Good Sam RV Club Member
Offline
|
Flex copper pipe similar to my furnace at home. Chris
My Rig
2001.5 2500 STD CAB AUTO SLT 4x4, CTD 4:10's, Bomb'd to Tow
2005 Cardinal 29WBLX.
|
Chris Bryant

DeLand, Florida, USA

Senior Member

Joined: 03/26/2003

View Profile

|
That is to code as long as the hose assembly is UL listed. There are a couple of rigs out now that use entirely non-metallic LP lines.
-- Chris Bryant
My RV Service Blog
The RV.net Blog
|
jauguston

Bellingham, WA

Senior Member

Joined: 07/03/2005

View Profile

Offline
|
There is a specific hose made for high pressure propane. I have used it for my heaters for the last 7 years running from the coach tank to the front area on three different coaches. I trust the hose more than vibration crack susceptible copper.They use copper because it is cheaper.

Jim
2005 Coachman Sportscoach Elite 402 40'
350hp Cat C-7 w/MP-8
7500w Onan quiet diesel generator
6-Kyocera 130w solar panels SB3024i MPPT controller
Pressure Pro TPMS
1987 Suzuki Samurai tintop Toad w/VW 1.6 turbo diesel power
|
Dutch_12078

Great Sacandaga Lake, NY

Senior Member

Joined: 10/07/2008

View Profile

Offline
|
My old 1986 Dolphin Class C had a rubber hose connecting the Suburban furnace to the LP distribution piping, but my 1995 Coachmen has a copper line connecting the Hydroflame furnace. The RVIA does not establish the building codes for RV's. They do however, require that their members comply with the applicable NFPA codes and other standards in order to get the RVIA label for a particular model. NFPA 58, the LP gas code, does not prohibit the use of appropriately rated hoses or plastic tubing for residential or vehicle use. Keep in mind, the LP distribution plumbing in an RV is operating at a very low pressure.
Dutch
1995 Coachmen Catalina 322QBXL
F53 chassis, 460 V8, TST TPMS
Quadra Bigfoot EZ Levelers
2011 Toyota RAV4 4WD/Remco pump
ReadyBrute Elite tow bar/Blue Ox baseplate
|
|
|
Corkey05

Washington State

Senior Member

Joined: 06/04/2005

View Profile


Good Sam RV Club Member
Offline
|
My kitchen is in a slide out, .. that includes the stove and a furnace, both have LP provided through a rubber flex hose. Like Dutch said, everything inside the coach is on the low pressure side of the regulator.
* This post was
edited 02/08/12 06:11pm by Corkey05 *
2008 HR Endeavor PDQ - Blazer 4 Down
FMCA F374292
|
jauguston

Bellingham, WA

Senior Member

Joined: 07/03/2005

View Profile

Offline
|
To add to what Dutch posted I on the other hand I am running tank pressure to my heater. The high pressure propane hose is rated for 300 psi and sees no more than 100 psi. The little green one pound tanks have the same pressure as the coach tank and all the plumbing in the heater before its regulator do too. The heaters are rated for safe use in enclosed inhabited spaces when the directions are followed regarding provision of fresh air. Fot that heater the requirement is a opening the equivelent of a 3" diameter hole. We satisfy that by slightly opening one of the roof vents.
* This post was
edited 02/08/12 12:41pm by jauguston *
|
Ex-Tech

West

Senior Member

Joined: 08/27/2011

View Profile

|
The corrogated "flex" copper should never be used in a RV. Never!
These lines are not made to withstand constant vibration. I sell these where I work and wanted to use one when I installed my Wave heater so I called the manufacturer and they stated what I said above.
|
dougrainer

Carrolton, Texas

Senior Member

Joined: 06/11/2007

View Profile

Offline
|
Remember, the Rubber hoses used in RV's AFTER the regulator are only handling LOW pressure. Rubber hoses are used in RV's for low pressure all the time especially in slide rooms that have LP appliances and other areas that you cannot run copper lines to. NEVER use anything but UL approved Rubber or hard copper lines, no flex metal lines at all. Doug
|
TMBLSN

Washington State

Senior Member

Joined: 04/07/2008

View Profile

|
They used this when I had a natural gas fireplace installed a few years ago at home.

Says that it's rated for LP and natural gas.
|
|
|